Step 2: Prepare the Flowers
Separate the flower bunches and trim each stem to approximately 3 to 4 inches using scissors or wire cutters. Keep a few stems slightly longer for the outer edges of the arrangement where you may want flowers to cascade outward at an angle. If your dollar store flowers come in large bunches attached to a single thick stem, use wire cutters to separate them into individual sprigs. Remove any plastic leaves that look unnatural and replace them with the faux eucalyptus or greenery you purchased separately.
Step 3: Attach the Flowers Upside Down
This is the step that creates the signature look. Hold a flower head against the bottom edge of the hoop with the flower facing downward — the stem pointing up, the bloom pointing toward the floor. Apply a generous amount of hot glue to the stem where it contacts the hoop, then press firmly and hold for 10 to 15 seconds until the glue sets. For extra security, wrap a small piece of floral wire around the stem and the hoop after gluing, then twist to tighten. Work your way around the bottom half of the hoop, attaching flowers at varying angles — some pointing straight down, others angled slightly outward — to create a full, layered look rather than a flat row. Fill in gaps with greenery sprigs, also glued with their stems pointing upward so the foliage cascades downward alongside the flowers.
Step 4: Fill the Top Half
The top half of the hoop serves as the visible frame above the flower cascade. You can leave it bare for a minimalist look, wrap it in jute twine or ribbon for texture, or add a light layer of greenery around the upper arc. Many people add just a few accent flowers to the top as well, creating a full 360-degree arrangement. If adding flowers to the top half, attach them with their heads facing outward and slightly upward rather than downward, so the overall visual effect reads as flowers cascading from the hoop rather than a wreath with downward-facing blooms on all sides.
